In this article, we’ll discuss how to make acrylic Photocard Holders keychains and how to seal them so they stay protected. You can also use a silicone tipped tool to apply UV resin to the acrylic. This will form a bubble-like ridge on the edge of the acrylic. Care should be taken to not get UV resin into the hole in the keychain.

How to make acrylic keychains

If you want to create custom keychains, you can add a monogram or other text to them. For this, you need a UV resin and a silicone tipped tool. First, prep the acrylic by wiping it clean using isopropyl alcohol. Then, burn a vinyl monogram onto the acrylic using the vinyl monogram font available in the Ultimate Crafter’s Font Bundle. When applying UV resin, use a silicone mat to protect your work surface.

Once your custom keychains are printed, seal them well with an acrylic sealant. These sealants protect your artwork from water and are ideal for gifting. They can also double as zipper pulls, ornaments, or gift tags. And you can customize them further by applying stickers or paint. This way, you can create unique keychains for every occasion.

How to seal acrylic Photocard Holders

Before applying the UV resin, prep the acrylic with a paper towel soaked in isopropyl alcohol. If you are using a vinyl monogram, burn it onto the acrylic first. A good font for this is included in the Ultimate Crafter’s Font Bundle. You can also use a silicone mat to protect your work surface.

After applying the UV resin, carefully remove the acrylic keychain from the UV lamp. It will be very hot, so be careful not to burn yourself. The resin should be hard but not sticky. After the resin has cured, you can decorate the keychain with charms, tassels, and beads. To personalize your keychains, consider using a font designed for monograms.

How to seal acrylic Photocard Holders keychains

If custom keychain you want to create your own unique acrylic keychains, you’ll want to know how to properly seal them. There are a few important steps to follow when applying UV resin. You want to make sure the resin is smooth, and not too thick. You also don’t want the resin to spill over the edges of your acrylic, so you want to make sure it is evenly applied. And remember, UV lamps are required to dry the resin.


First, you’ll want to cut out your design. After printing, the acrylic keychains will shrink a little bit. If you are unsure of the exact size, use glue to adhere the two sides together. Once that’s dry, cut out your design, leaving a border.


Leave A Reply